The Chief 700 is patended and unique in terms of Care, Service and Maintenance :
1. Minimal service tools are required (1 x Wrench, 1 x Screwdriver) to dis-assemble and re-assemble the entire machine-all parts
2. It is Field Strippable-pretty much BY HAND-of major components including All Electrical Replacement requirements. The Chief-700 can be dis-assemble and re-assembled by HAND.
Specification :
| MOTOR/BLOWER SAMSUNG |
VAC/Hz AMPS WATTS RPM |
230-240 Volt/ 50/60 Hz 5.6 700 Watts 37,000 +/- 1500 |
| AIR VOLUME-OUTPUT | 2910 lts/minute | |
| VACUUM | 24.0 kPa | |
| FORMULATION TANK | Capacity in litres with Graduated markings | 4 lt STD. (5 lt, 6lt with 9lt Optional) |
| FLOW RATE VALVE | Adjustale/Variable Output Maximum Flow Rate |
Needle Valve, Brass, SSTL (Optional) 60 lts/Hr |
| SET FLOW RATE VALVES | FSFR Valves, BRASS, SSTL Optional | Set of 5 : #20 = 5 lts/Hr, #28 = 10 lts/Hr, #37 = 16 lts/Hr, #42 = 21 lts/Hr, #47 = 26 lts/Hr |
| DROPLET RANGE | Visible*metres | 15-20 metres |
| APRTICLE SIZE DIAMETER | Measured in microns (μm) | 5-50 μm |
| NOZZLE | Vortical in that the spray swirls on exit DIFUSER-Material Face Plate Replaceable Air Bleed |
NOVA-MIST Vortical Adjustable Nozzle HDPE Yes Yes |
| Material-Construction | Motor Housing/Nozzle Formulation Tank Protective Tank “Boot” Fittings Eternal Delivery Lines Internal Delivery Lines-Housing and Tank “O” Ring Material/in-Tank Filter |
HDPE HDPE Rubber Brass, SSTL-Optional Nylon Brass, SSTL-Optional VITON |
| Multi-Purpose Use | Application of Insecticides, Fungicides, Foliar, Fertilizers, Disinfectants, Sanitizers | |
| Tank Opening Ports | YES-Each comply with W-H.O Guideliness | >90mm diameter |
| Formulation Filter | In-Tank Push on Filter | SSTL Mesh with VITON Support |
| Warranty | Conditional | 24 months |
| Shipping Dims | 36.0 cm x 36.0 m x 52.0 cm | |
| Volume(Packed) | Cubic Metres | 0.07 m³ |
| Weight (kgs) | 5.5 kgs | |
| ADDITIONAL FEATURES | ||
| Screw Cap. Assembly | No screws-plastic to plastic Motor is secured in Housing with a Screw Cap, Nozzle is secured by a Screw Cap, Formulation Tank+Housing Secured with a Screw Cap | |
| Insternal Sound Dampner | Noise Suppressor Capacitor | |
| Heat Sink-Heat Shield | Within Motor Housing | |
| Thermal Cut Out | For Motor Protection | |
| TORQUE CONTROL | Motor Torque Control to counter the motor wanting to spin inside of the Housing-Completely elimination electric wiring twist | |
| 2 Part Wiring | To allow easy removal of motor rom the attached wiring for maintenance purpose |
